CONTROL SYSTEM - Tp600

We've made these videos/guides to make sure that you have all the information needed to maintain your brand new hot tub.

Adjusting the Temperature

Flipping the Screen

Change the High/Low Range

If your Hot Tub isn't heating to your desired Temperature, this could be because the Range is on LOW.

To change the range to HIGH, enter into your control settings by pressing WARM and then LIGHT.

The "RANGE" text will begin to flash. To set the range to HIGH, press the UP arrow to make the arrow point upwards on the display.

Once you have selected, press the LIGHT button once which will lock in your selection.

Ready & Rest Mode

The initial temperature that's displayed is the current temperature in your Hot Tub.

To switch between READY and REST modes, enter into your control settings by pressing WARM and then LIGHT. 

Press the LIGHT button until "MODE" is displayed with either "READY" or "REST" flashing.

Once you have selected, press the LIGHT button once which will lock in your selection.

Setting the Time

To set the time on your hot tub, enter into your control settings by pressing WARM and then LIGHT.

Press the LIGHT button enough times until you see "SET - TIME" shown on the screen.

To set the hours, press the WARM button once and then alter by using the UP and DOWN arrows.

Once you have selected, press the LIGHT button which will lock in your selection.

To set the time on your hot tub, enter into your control settings by pressing WARM and then LIGHT.

Press the LIGHT button enough times until you see "FLTR" shown on the screen.

Press the WARM button to set the beginning of the cycle. Press the WARM button to set the hour, using the WARM and COOL button to increase and decrease and LIGHT to confirm and then navigate.

Watch video above for more options and settings.

How to set filter cycles

The initial temperature that's displayed is the current temperature in your Hot Tub.

To set your desired temperature, use the UP or DOWN arrows to change - going through 1/2 degree segments.

Once you have selected, remove your finger and the temperature will automatically lock in your selection.

The initial temperature that's displayed is the current temperature in your Hot Tub.

To flip your display, enter into your controls settings by pressing WARM and then LIGHT.

Press the LIGHT button once which will lock in your selection.

MAINTENANCE TIPS.jpg
CHEMICAL ADVICE.jpg

We understand that when there's an issue with your hot tub, it can interrupt the pleasure that your hot tub is designed to bring you. That's why we try to make it easy as possible to help with rectifying any issues you have, no matter how big or small.

Please note that the showroom will not be able to deal with any problems or issues relating to your hot tub or its installation as these are dealt with by our dedicated repairs and maintenance department. 

When you raise a ticket using the link below you will be contacted directly by our Repairs and Maintenance Manager who will endeavor to resolve the issue ASAP. Many thanks.