top of page

CONTROL SYSTEM

Change the High/Low Range

If your hot tub isn't heating to your desired temperature, this could be because the range is on LOW.

To change the range to HIGH, enter into your control settings by pressing MENU. You will see the arrow flash, indicating that is selected and can be adjusted between HIGH or LOW.

To set the ranges, press either the UP or DOWN arrow to swtich between modes. Once you have selected, press the MENU button once, this will lock in your selection.

Ready & Rest Mode

The initial temperature that's displayed is the current temperature in your Hot Tub.

To switch between READY and REST modes, enter into your control settings by pressing MENU till you see "MODE".

By pressing the UP and DOWN button, you will move through "READY" and "REST". 


The "R" upright = "READY", the "R" sideways = "REST".

Once you have selected, press the MENU button once which will lock in your selection.

Setting the Time

To set the time on your hot tub, enter into your control settings by pressing MENU enough times until you see "SET - TIME" shown on the screen.

To set the hours, press the WARM button once and then alter by using the UP and DOWN arrows. Using the MENU button to confirm the hours and move onto minutes.

Once you have selected, press the MENU button which will lock in your selection.

To set the filter cycle, enter into your control settings by pressing MODE. Press the UP button enough times until you see "FLTR" shown on the screen.

Press the WARM button to set the beginning of the cycle, then MENU to select confirm FLTR 1.

 

Press the UP and DOWN buttons to set the hour, then confirm by pressing MENU to then select minutes.

 

Repeat process for FLTR 2.
 

How to set filter cycles

bottom of page